satin car wrap Remove antenna for vinyl film wrapping

satin car wrap

Wrapping a roof with vinyl wrap is more difficult when there's an antenna. You have to spend energy and time dealing with the raised object. satin car wrap It is easier and more efficient to remove the antenna. These are two ways to get rid of an antenna. satin car wrap Your situation will dictate which approach you choose. Find the light An antenna mounted on the roof allows you to see the ceiling of the vehicle. You have a good chance of taking it off if there is a light underneath it.

Car Wrapsm

You can remove the cover with light using a plastic tool. Once you have removed the cover, satin car wrap the bolt holding the antenna will be visible. You can loosen the bolt and disconnect the electrical connection from the inside. Once these are complete, satin car wrap you can pull the antenna from the outside and remove the wire. www.vinylcarwrapshop.com You can now treat the roof flat and wrap it in vinyl wrap film. Make sure to clean the antenna thoroughly before installing it. Take down the roof liner Sometimes there is no light in the ceiling directly below the antenna. To access the bolt, you will need to remove the roof liner. You can hold the panel on with plastic molding or fabric. satin car wrap You should be cautious as you may bend the roof liner in either case. After removing the roof panel, satin car wrap reach for and loosen the bolt that holds the antenna. Then disconnect the wire the same way. Once these are completed, remove the antenna from the outside. You can then wrap the roof with vinyl wrap as usual. After everything is completed, satin car wrap place the antenna carefully. Get more tips on roof installation at teckwrap.com antenna hardware Removal

---