purple metallic car paint For easier vinyl wrapping, remove back lights

purple metallic car paint

It is common to remove hardware when wrapping cars with vinyl wrap film. purple metallic car paint This will allow you to wrap the car more effectively and give it a full coverage. These are the steps to remove different types of rear light bulbs from a vehicle. (You can also visit teckwrap.com for more information on how to remove other hardware. Rear lights are usually held together by two bolts or screws, along with safety clips. Once you locate the access point, it is easy to remove the lights.

Car VinylWrap

Standard case The trunk's interior is usually where the bolts or screws are located. These can be loosen with the appropriate tools. purple metallic car paint You can also use a plastic remover tool to lift the lights from the outside. This will prevent you from damaging the clips. As you unplug the wire, purple metallic car paint pull the light off. You should be careful when removing the rear lights. The bolts have sharp pegs that can scratch the vehicle's body. Do the job from the outside Wrapping a cargo van in vinyl wrap film is easier as the access point can be found on the exterior of the light. purple metallic car paint You can use masking tape to cover the holes and keep them safe until you are done. You should look for a small entrance If you wish to take out the rear lights on a hatchback, you'll need to open the back door to see inside. purple metallic car paint You may then find the small door where the bolts or screws are hidden behind a panel. Take out the interior panel Rarely, the access point may be hidden behind the trunk's interior panel. You will need to remove enough of the trunk to reach the bolts or screws for the rear lights. purple metallic car paint The electrical connector is usually hidden behind the rear light. www.vinylcarwrapshop.com You can also disconnect it at the same time. After the rear lights have been removed, you can wrap the area in vinyl wrap without stress. Wrapping the area around the lights with vinyl wrap film can be extended and will make it look cleaner. purple metallic car paint Make sure to check that the lights are working properly before you put them back. Have a happy wrapping. Backlight Removal

---